We lieten in een vorige post al vallen dat er een update onderweg is naar Halo 5, in deze update zit ook de Advanced Controller opties. Met deze update kan je nog meer instellen hoe je schiet en mik, zoals Look Acceleration, Inner Dead Zone, en Outer Dead Zone.
Inner Dead Zone, is de regio om de analoge stick waarna de input word geregistreerd, dit moet gaan voorkomen dat de camera gaat driften terwijl je de controller niet aan raak. Soms gaan de sticks namelijk niet terug naar het perfecte centrum. Deze optie moet hiervoor zorgen.
“Try turning the Inner Dead Zone down to 0 percent and test if you run into cases where after releasing the look stick, the camera continues drifting,” aldus 343. “If you do get drift, increase the inner dead zone setting a bit and try again. Ideally, you want as small of a deadzone as possible so that you’re maximizing as much of the analog stick as possible.”
“Outer Dead Zone is used to prevent slow turn (when you are applying 100 percent input on the look stick but not reaching top look speed). The larger the Outer Dead Zone, the sooner you will hit 100 percent,” volgens 343.
Ook hiervoor heeft 343 instructies achter gelaten :Ā “Try turning the Outer Dead Zone down to 0 percent and test if you run into cases where you can’t hit the ‘pegged state’ and encounter slow turn,” aldus 343. “If you do get slow turn, increase it a bit more and try again. Note that the majority of cases we found where people were encountering slowturn were somewhat hard to discover as the problem tended to be inconsistent and were often happening only when clenching, torqueing, or rotating the analog stick around the edges a tad. So you might need to experiment with this one a tad more before settling on the proper setting.”